11
Directions for use
1
On/Off
The water heater will be switched on after the “On / Off” button is pressed. The default
status of the control board working for the first time is as follows: heating light is turned
on; default setting of the temperature is 70°C; actual temperature will be displayed in the
LED panel.
2
Temperature Setting
This water heater displays the actual temperature and the set temperature based on key
pressed. The actual temperature refers to the temperature of the water in the water heater;
the set temperature refers to the temperature that the user expects the water heater to
reach while heating the water. The user can choose to change the set temperature any time
by pressing the “
“ or “
“ button. When user presses the “
” or “
” button, the digital
LED will flash and display the setting temperature, when user stops pressing the “
“ or
“
“ button, the digital LED stops flashing. 4 seconds later, when the temperature setting is
completed then the LED displays the actual temperature.
Fig. 9 Wired remote controller
Caution:
• Before using the water heater, make sure the inner tank is completely filled with
water and the power plug has been connected properly.
• Operating the water heater with insufficient or No water may result in permanent
damage to the water heater and may cause damage to the property and injuries to
the users.
• It is recommended that the wired remote controller should be installed on the
remote bracket (Fig. 8). Ensure that the wired remote controller does not get in direct
contact with water. do not use wet hands while operating the remote.
Warning:
• The wired remote controller works with the power of water heater (No separate
power connection or battery required). Do not open the wired remote controller.
On / Off
Increase
Decrease
Timer
Heating
Indicator
Test
Display LED
