A-LINK WNAP4G User Manual
78
2.
Get Community
: The community of GetRequest is that this device will
respond.
3.
Set Community
: The community of SetRequest is that this device will
accept.
4.
IP 1, IP 2, IP 3, IP 4
: Enter the IP addresses of your SNMP Management
PCs. User has to configure where this device should send SNMP Trap message.
5.
SNMP Version
: Select proper SNMP Version that your SNMP Management
software supports.
6.
WAN Access IP Address
: If you want to limit the remote SNMP access to
specific computer, please enter the PC’s IP address. The default value is 0.0.0.0,
and it means that any Internet connected computer can get some information of
the device with SNMP protocol.
Afterwards, click on
“Save”
to store your settings or click
“Undo”
to give up the
changes.
