A.J.Antunes VCT-200 Series, Руководство пользователя

Страница: 18 / 28

RAPID TOASTER VCT-200
18
P/N 1010710 Rev. N 02/13
McDonald’s
Problem Possible Cause Corrective Action
Grrovy Belt Wrap does not fit,
is difficult to install, or is not
long enough
Groovy Belt Wrap is installed improp-
erly.
Check to be sure Groovy Belt WRap is not
placed over upper or lower Support Rods.
Be sure the open end of the flap is away
from the direction and rotation, and is l
ocated toward the outside of the Groovy
Belt Wrap.
Groovy Belt Wrap is damaged. Replace Groovy Belt Wrap.
The only item that operates is
the cooling fan (conveyor and
heat inoperable.
Hi-Limit Control is tripped open. Reset Hi-Limit Control as showin in the
Maintenance section of this manual.
Note: If the Hi-Limit trips again, contact
your Authorized Service agency for ser-
vice.
Platen is hot and Conveyor
Belt/Chains do not move.
Conveyor Cover Assemblies not
installed.
Install Conveyor Cover Assemblies.
Conveyor Belt/Chains installed incor-
rectly.
Install the Conveyor Belt/Chains according
to the Maintenance Section of this manual.
Be sure the ends of the hooks are facing
down.
One or both Conveyor Interlock
Switches not activated by Conveyor
Covers.
Install Conveyor Cover Assembly correctly
according to the Maintenance section of
this manual.
Buns are not toasting prop-
erly.
Compression Settings are incorrect. Set the Bun Thickness Compression
Controls to “D & 5” for 17 second toasters.
For 10 second toasters, set the controls to
“B & 3” (see Figures 2A & 2B).
Toaster temperature not set properly. Verify the toaster is set at SP-P 560° F
(293° C) for the Platen, and SP-A 400°
F (204° C) for the auxiliary. Refer to the
Operation section of this manual.
Release Sheet dirty or worn. Follow cleaning and replacement proce-
dure on the current MRC, TS 019.
Groofy Belt Wrap dirty or worn
Bun temperature below 150° F (65.6°
C).
Perform the bun temperature test as
described on the current MRC Card.
Replace worn Dampers and/or missing
Springs.
Contact your Authorized Service Agency
for these parts
Buns cut improperly. Contact your bun supplier.
Crown and/or heel must be
forced into toaster.
Bun Feeder improperly installed. Remove and reposition Bun Feeder.
Groovy Belt Wrap not tacky or is
worn.
Clean or replace Groovy Belt Wrap.
Crown and/or heel improperly insert-
ed into toaster.
Buns must be inserted with cut faces fac-
ing inward towards each other; heel in front
slot and crown in rear slot.
Groovy Belt Wrap slipping over
Conveyor Belt Chains.
Clean Conveyor Belt/Chains according to
the Maintenance Section of this manual.
TROUBLESHOOTING (continued)