4pos POS-400 Expander II, Руководство пользователя

Страница: 32 / 62

25
Pole-Type 2nd Display Module Installation
1. Turn off the system power properly through the operating system, then turn off any external
devices.
2. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION: Regardless of the power-on state, voltage is always present on the main board as
long as the system is plugged into an active AC outlet. You must disconnect the
power cord to avoid damage to the internal components of the system.
3. Unscrew the I/O cover, slide it out, and store in a secure location for possible future use.
4. Connect 8.9inch pole display module both end connector to POS-400 Expander II COM6 port and
VGA port respectively. If you are installing pole type VFD, it has only a VFD cable to connect to
POS-400 Expander II COM6 port. Then the plastic clip on the I/O cover must lock over the end of
the base.
5. Secure the two screws under the I/O cover and one screw above the I/O cover.
6. Reconnect the power cord and any external devices, then turn on VFD/LCD power. Finally, turn on
the system power.
NOTE: The Pole mound VFD module please follow the same step but just need put
connect into POS-400 Expander II COM6 port. And its configuration utility be put
under <CD>\ Optional Module Data & Tool\VFD\PoleMount VFD . If you need it,
please execute the utility under <CD>\ Optional Module Data & Tool\
VFD\PoleMount VFD
COM6