4O3A Signature – Antenna Genius User Manual
Page
27
of
56
8.12.
Manual Mode
The manual mode is a new, special mode that’s used for testing and debugging of your
configuration.
When the manual mode is enabled, you will be able to see the band manually and by doing so,
verify that your configuration is exactly as you want it to.
In order to use the Manual mode on your Antenna
Genius, go to the app and click on the band source
button then select MANUAL.
Below the band source selection button you will now
be able to click on the band and manually select the
band.
Band sources for each radio port are selected
independently so make sure to set both ports to the
desired band source.
9.
ANTENNA GENIUS
tm
APP
The AG App is used to perform seven tasks:
1.
Fully configuring your Antenna Genius.
2.
Programming band-antenna assignments for automated operation: antenna selection
driven by radio band data received directly from a FlexRadio, radio, manually, or relayed
through a logging software.
3.
Secondary antenna selection when there is more than one antenna available for a band.
AG will default to last antenna selected for a particular band in automatic mode after
which operator can manually select an alternative antenna for that band. Note that you
will be prohibited from switching to antennas which have not been programmed for the
band in question (unless band is set to none, rendering the antenna as band
independent).
4.
Providing a Windows interface for manual antenna selection, an alternative to
automated antenna selection as well as powerful relay control for automation.
5.
Allowing multiple users to use one switch.
