4O3A Signature – Antenna Genius User Manual
Page
15
of
56
8.
HARDWARE
EXPERT TIP!
Read this and the following Software section carefully before changing any DIP switches
or software settings.
8.1.
Front panel
Front panel features:
•
SO-239 (or N-female) connector for Port A
•
SO-239 (or N-female) connector for Port B
•
8 SO-239 (or N-female) connectors for antenna inputs
•
LEDs: red LEDs indicate which A port antenna has been selected and green LEDs indicate
which B port antenna is selected
8.2.
Bottom panel
Bottom panel features:
•
LAN: RJ-45 jack connects to your home/shack network (assumes you are using the
network control option as most Flex users will be)
•
Two DE-15 VGA-type for users opting for BCD or +12 VDC pin-to-port control in lieu of
network control, for controlling standard radios as Yaesu, Elecraft etc. These are left
unconnected if you are using network control (most FlexRadio equipped stations won’t
use these ports)
•
12-15VDC: connect your shack 13.8 VDC power supply here paying attention to proper
polarity, anywhere from 12 to 15 VDC with at least 300 mA will be OK
•
OM module: enables connecting the 16 relay Output Module for station automation
•
DIP Switches: The side panel has 8 DIP switches for resetting the configuration.
AG can be controlled four different ways: (1) LAN, (2) BCD, (3) Pin-to-Port. The control mode is
set independently for Port A (Radio A) and Port B (Radio B) by the DIP switches. For example,
Port A could be controlled over the network and Port B could be controlled by BCD signals.
