Chapter 2. Primary CLI Syntax Reference
32
3ware 9000 Series Serial ATA Controller CLI Guide
/cx show numports
This command reports the port capacity (number of physical ports) of the
specified controller /cx.
Example:
//localhost> /c0 show numports
/c0 Number of Ports = 12
/cx show numunits
This command reports the number of units currently managed by the specified
controller /cx. This report does not include off-line units (or exported units).
Example:
//localhost> /c0 show numunits
/c0 Number of Units = 1
/cx show numdrives
This command reports the number of drives currently managed by the
specified controller /cx. This report does not include (logically) removed or
exported drives. Also note that physically removed disk(s) will not be
detected unless I/O is performed against the disk. See “/cx/px show smart” on
page 69 for a workaround.
Example:
//localhost> /c0 show numdrives
/c0 Number of Drives = 5
/cx show exportjbod
This feature only applies to 9000 series controllers.
This command reports the current JBOD Export Policy:
on
,
off
, or
Not
Supported
.
Example:
//localhost> /c0 show exportjbod
/c0 JBOD Export Policy = Not Supported.
//localhost> /c1 show exportjbod
/c1 JBOD Export Policy = on
/cx show spinup
This feature only applies to 9000 series controllers.
This command reports the number of concurrent disks that will spin up when
the system is powered on, after waiting for the number of seconds specified
with the
set stagger
command.
Example:
