3Ware 3WARE 9650SE, Руководство по установке

Страница: 23 / 42

Step 3 (Multilane Controllers). Connect the Cables to the Drives or Back-
www.3ware.com 19
Step 3 (Multilane Controllers). Connect
the Cables to the Drives or Backplane
For the 9650SE-4LPML, 9650SE-8LPML, 9650SE-12ML, and
9650SE-16ML models, follow the steps below. (For the 9650SE-
2LP, turn to the previous page.)
1 If your drives are not already installed, install them now, either
by attaching them to the backplane, or by installing them in the
computer chassis.
If appropriate, set the PM2 (power management) jumper on the
disk drives, to enable staggered spinup. Check the
documentation that came with your disk drives to see whether
this is required.
2 If your enclosure has a multilane drive backplane, connect the
other end of each multilane cable to the backplane.
If you are using a breakout cable, select one of the ends and
plug it into each drive or drive carrier.
One edge of each SATA cable connector is keyed to ensure
proper installation.
Figure 13. SATA End of Breakout Cable Connecting to Drive
3 Be sure that the power supply is connected to either the
backplane or the individual drives, either by cable or through
the drive carrier.