3Ware 3WARE 9650SE, Руководство по установке

Страница: 22 / 42

Chapter 2. Installing Your 3ware RAID Controller
18 3ware 9650SE Serial ATA RAID Controller Installation Guide
Step 3 (9650SE-2LP). Connect the
Cables to the Drives
For 9650SE-2LP controller, follow the steps below. For other
9650SE models, turn to the next page.
1 If your drives are not already installed in the computer chassis
or hot swap carriers, install them now. Be sure that the drives
are connected to the power supply, either by cable or through
the drive cage.
If appropriate, set the PM2 (power management) jumper on the
disk drives, to enable staggered spinup. Check the
documentation that came with your disk drives to see whether
this is required.
2 For each drive, select the end of an SATA cable not connected
to the 3ware RAID Controller and plug it into the drive or drive
carrier.
One edge of each SATA cable connector is keyed to ensure
proper installation.
Figure 12. SATA Cable Connecting to Drive