3M™ MicroTouch™ Chassis Display User Guide
9
3M Touch Systems, Inc. Proprietary Information -- 37762v01
•
To avoid ergonomic concerns:
Do not install the display in a manner or location with awkward accessibility.
Extended use may result in muscle, tendon, or fixed posture strains. It is
recommended you take periodic breaks from continuous use.
Service and Repair Indicators
Do not attempt to service this unit yourself. Removing the display cover may expose you
to dangerous voltages or other risks. Unplug the display from the power outlet and refer
servicing to qualified service personnel in the event that:
•
Liquid is spilled into the product or the product is exposed to rain or water.
•
The product does not operate properly when the operating instructions are followed.
•
The product has been dropped or the metal case has been damaged.
•
The product exhibits a distinct change in performance, indicating a need for service.
•
The power cable or plug is damaged or frayed.
Touch Sensor Care and Cleaning
The touch sensor requires very little maintenance. 3M Touch Systems recommends that
you periodically clean the glass touch sensor surface. Be sure to turn off your display
before cleaning.
Typically, an isopropyl alcohol and water solution ratio of 50:50 is the best cleaning
agent for your touch sensor. You can also use straight isopropyl alcohol.
CAUTION
To avoid the potentially hazardous situations associated with the use of alcohol
or other solvents which may result in minor or moderate injury or property
damage:
•
Follow all instructions and recommendations in the manufacturer's Material Safety
Data Sheet and product label.
•
Be sure to follow solvent manufacturer's precautions and directions for use when
using any solvents
•
It is important to avoid using any caustic chemicals on the touch sensor. Do not
use any vinegar-based solutions.
•
Apply the cleaner with a soft, lint-free cloth. Avoid using gritty cloths.
•
Always dampen the cloth and then clean the sensor. Be sure to spray the cleaning
liquid onto the cloth, not the sensor, so that drips do not seep inside the display or
stain the bezel.