6
3M™ MicroTouch™ Chassis Display User Guide
3M Touch Systems, Inc. Proprietary Information -- 37762v01
Important Safety Information
Read and understand all safety information before using this product. Follow all
instructions marked on the product and described in this document. Pay close attention to
the following installation warnings and safety precautions.
Intended Use
The 3M Touch Systems SCT Chassis Display was designed for touch input and tested
to replace an existing display. These displays are intended for indoor use only and are
not designed for use in hazardous locations.
Explanation of Signal Word Consequences
DANGER:
Indicates a potentially hazardous situation, which, if not avoided, will
result in death or serious injury and/or property damage.
WARNING:
Indicates a potentially hazardous situation, which, if not avoided,
could result in death or serious injury and/or property damage.
CAUTION:
Indicates a potentially hazardous situation, which, if not avoided, may
result in minor or moderate injury and/or property damage.
CAUTION:
Indicates a potentially hazardous situation, which, if not avoided, may
result in property damage.
DANGER
To avoid the risk of fire and/or explosion which will result in serious injury or
death:
•
Do not install or use this product in a hazardous location.
WARNING
To avoid the risk of fire which could result in serious injury or death:
•
Do not remove the cover or back of the display -- dangerous voltages inside.
To avoid the risk of electric shock which could result in serious injury or death:
•
Do not remove the cover or back of the display. The backlight inverter output is at
high voltage.
•
This device must be operated with the original power supply and cable provided as
shown below:
•
LITEON PA-1081-01 or EDAC EA11001C-120 for the C2254SW
•
LITEON PA-1041-0 or EDAC EA10521E-120 for the C2234SW
•
Do not use a damaged power supply.
•
Plug power cord into appropriate grounded power source.
•
Do not use a power cord that is frayed or otherwise damaged