8
3M™ MicroTouch™ Chassis Display User Guide
3M Touch Systems, Inc. Proprietary Information -- 37762v01
CAUTION
To avoid possible environmental contamination which may result in minor or
moderate injury:
•
The lamp(s) inside this product contain mercury (Hg) and must be recycled or
disposed of in accordance with local, state, or federal laws. Check your individual
state's requirements to see if specific recycling requirements exist for mercury-
containing products or other electronic products. Refer to
http://www.nema.org/lamprecycle/
or call 3M Touch Systems 1-866-407-6666 for
further information.
•
Dispose of the flat panel display according to applicable governmental regulations
.
Important Notes
•
In extreme temperature and humidity situations, you may observe condensation
between the touch screen and the display. To minimize this condition, place the unit
where it will be used and allow a 24-hour environmental stabilization period prior to
powering on the display. Any noticeable condensation is temporary and will have no
long term affect on the operation of the display.
•
You are cautioned that any change or modification to the equipment not expressly
approved by the party responsible for compliance could void your authority to
operate such equipment.
•
When unplugging the power supply cord, hold the plug, do not pull by the cord.
•
Do not connect or disconnect this product during an electrical storm.
•
Remember to take into account that the operating temperature of the installation may
be greater than the room ambient, and consideration should be given to installing the
unit in an environment compatible with the maximum rated operating temperature.
Specifications can be found in the product data sheet on the 3M Touch Systems
website
at http://www.3m.com/touch/
.
•
When installing the unit, ensure that it does not restrict the flow of air to any other
equipment within the installation required for safe operation.
•
Install the display in a well-ventilated area. Always maintain adequate ventilation to
protect the display from overheating and to ensure reliable and continued operation.
•
Do not expose this display to direct sunlight or heat. Passive heat may cause damage
to the housing and other parts.
•
Do not install this display in areas where extreme vibrations may be generated. For
example, nearby manufacturing equipment may produce strong vibrations. The
vibrations may cause the display to exhibit picture discoloration or poor video
quality.
•
Ensure the metal enclosure does not contact the touch sensor.
•
Be sure to gasket the display to its enclosure properly to prevent damage to the touch
sensor.