11.2 While holding the jumper wires in place, close
the cap and press to snap the latch firmly into
place.
11.3 Route the jumper wires to distribution pair
through wire loops on block ends and through
vertical and horizontal wireways. Cut jumper
wires to appropriate length, leaving at least 5 cm
(2 in.) of slack.
11.4 Terminate the jumper wires to the distribution pair
by repeating the procedure described in steps 15.1
and 15.2.
11.5 Terminate additional jumper wires by repeating
the above procedure.
11.6 To remove jumper wires, open the cap and pull
wires straight out from block.
9
78-0013-7947-4-A
September 2015
