Pag. 23
DUALNET—6 INSTRUCTION MANUAL
ENGLISH
NOTE: If the end user wishes to know
which sensor has triggered the alarm,
low battery or tamper, it is best to
memorize only 1 sensor in each zone.
Group
0-1-2-3 = this means that each zone
may memorize up to 4 sensor codes
and the number 0 to 3 will indicate the
order in which they have been
Learned in each zone.
ActivateSensor
Delete Sensor
On the display appears:
To memorize To cancel
With keys or select “
Activate sensor
” to learn the Peg-3 “Pegaso” code.
If the panel does not learn the
code, the display will show “Failure” press the key and repeat
the above procedure once again.
If the Peg-3 code has been previously memorized, on the display will
appear “Update ?” By pressing the Peg-3 transmitter code will
moved to a new position and memorized.
NOTE:
If the password is in the same position, it may be cancelled. If
this takes place it must be again memorized.
Press once again if you wish to memorize additional Peg-3
transmitters otherwise press to return to the main menu.
ActivateSensor
Learning
With the Peg-3 keychain transmit-
ter press the Arm button and
send transmission with-in 20
seconds. See page 27.
Success
E
ActivateSensor
Failure
00SensorExists
Update?
E
E
#
If you desire to cancel a Peg-3 transmitter already memorized,
press the keys or until the Display shows: “Delete
sensor”. Then press to confirm.
Press to proceed.
E
12. PROGRAMMING THE WIRELESS SENSORS
Enter the programming main menu and go to the window
“Programming sensors”
Press the key
On the display will appear:
To select the zone number you must press the key 2 times and then select a zone from
15 to 44. These are the 30 wireless zones available. On the display will appear:
Every zone can memorize 4 different sensors codes. The group number indicates the sequence of
memorization. Press to cancel the previous number select a new number and confirm.
E
E
The zone 00 is associated to
the Peg-3. So the zone 00
must not be used for the
wireless sensors. Use only
the zones from 15 to 44.
ActivateSensor
Delete sensor.
Deleting Sensor
Success
E
Pr
Set Smart Zone
ogram Sensor
Zone Number
00
Group Number
0
