3Dlabs Wildcat 4210, Руководство пользователя

Страница: 23 / 34

17
Enabling Stereo Display
If you connect a device to the stereo port on the Wildcat 4210 video card, you must change the display
mode to view in stereo. See Chapter 2, “Setup,” for the location of the stereo output port on the video
card.
To enable stereo display:
1. Make sure your stereo display device is properly connected to the stereo output port on the
Wildcat 4210 video card.
2. Go to Start » Settings » Control Panel » Display. In Windows NT 4.0, click the Wildcat Monitor
tab if it is not already displayed. In Windows 2000, continue to Settings » Advanced and click the
Wildcat Monitor tab.
3. Click Configure Monitor.
4. Select a Stereoscopic Display mode from the Display Mode list box and then click OK.
5. You may see the following message: “The selected monitor cannot display the current desktop
area. Select a new resolution before applying these changes.” If you do, click OK and then select
a resolution from the list of available resolutions.
6. Click OK if the display is correct and you wish to keep the new settings.
7. Click OK to accept the new display mode.
You must disable stereo mode when you no longer wish to view in stereo. To do this, follow the steps
above, and select Monoscopic Display from the Display Mode list box.
Enabling Multiview and Genlock
The Wildcat 4210 video card features Multiview support for frame locking and rate locking of multiple
computers. Genlock support allows video timing to be synchronized to an external timing source.
NOTE Your application must support Multiview for Multiview to work.
NOTE Refer to the Support pages on the Wildcat Web site for information on ordering the
correct Multiview and Genlock cables.
To prepare computers to use Multiview:
1. Insert one end of a shielded RJ12 cable into the Multiview Out port (see Figure 10) of the first
computer. This computer becomes the “master”
2. Insert the other end of the cable into the Multiview In port (see Figure 10) of the second computer.
This computer becomes a “slave.”