Pannoramic SCAN 150 1.15 User’s Guide
5 Troubleshooting and Maintenance
5.
Hold the filter module
(3)
by its handling pads (one on the right, one on the left (lateral)
side of the module) and insert it in forward tilted position from above into the upper spring-
loaded clamps
(1)
at the filter wheel.
6.
Press the filter module down, until it safely connects to the bottom spring-loaded clamps
(2)
of the filter wheel. Mounting position of the filters: excitation filter
(5)
; emission filter
(4)
7.
To remove the filter module, first slightly tilt it out of its upper spring-loaded fixtures, then
pull it out of the bottom spring-loaded components and take it off.
8.
Place the protective covers back again (see
5.3.1 Removing the protective covers
).
9.
Turn the HXP120 illuminator on again (consider the cooling time possibly required).
5.3.6 Removing the magazine from the transporting system
Figure 77 – Removing a magazine
1.
Remove the protective covers (see section
5.3.1 Removing the protective covers
).
March 13, 2012 - Rev. 1
3DHISTECH Ltd.
123(132)
