3D AEROWORKS TRACER 2000, Руководство по сборке и инструкция пользователя

Страница: 12 / 19

6
Install the tail boom to the rear of the fuse. There is an optional small hole in the aft of the
fuse for a M2x20mm screw to secure the tail boom to the fuse, otherwise the tail boom can
be glued in place. Be sure to confirm the v-tail is level with the fuse before fixing the tail in
place.
7
Place tape at the end of each elevator to hold it level while connecting the fishing line to the
elevator. It is advised that the servo’s be centered and programmed before connecting the
control lines. Place a drop of CA on the knot to secure it. The knot should be firm and not
overly tight, if it is too tight you risk adjusting the angle of the tail-plane which could lead to
adverse flying characteristics.