3Com Switch 7700, Руководство по настройке

Страница: 37 / 390

Ethernet Port Overview 29
Setting Duplex Attribute of the Ethernet Port
Set the port to full duplex to send and receive data packets at the same time. Set
the port to half-duplex to either send or receive only. If the port has been set to
auto-negotiation mode, the local and peer ports will automatically negotiate the
duplex mode.
Perform the following configuration in Ethernet port view.
The 100 Mbps TX Ethernet port can operate in full-duplex, half-duplex, or
auto-negotiation mode. The Gigabit TX Ethernet port can operate in full duplex,
half duplex, or auto-negotiation mode. When the port operates at 1000 Mbps,
the duplex mode can be set to full (full duplex) or auto (auto-negotiation).
The optical 100M/Gigabit/10Gigabit Ethernet ports support full duplex mode and
can be configured to operate in
full (full duplex) or auto (auto-negotiation) mode.
By default, the port is in auto (auto-negotiation) mode.
Setting the Speed of the Ethernet Port
You can use the following command to set the speed on the Ethernet port. If the
speed is set to auto (auto-negotiation) mode, the local and peer ports will
automatically negotiate the port speed.
Perform the following configuration in Ethernet port view.
Setting Cable Type for Ethernet Port
The Ethernet port supports the straight-through (MDI) and cross-over (MDIX)
network cables. The Switch 7700 only supports auto (auto-sensing). If you set
some other type, you will see an error message. By default, the cable type is auto
(auto-recognized). The system will automatically recognize the type of cable
connecting to the port.
Perform the following configuration in Ethernet port view. The settings only take
effect on 10/100BASE-T and 10/100/1000BASE-T ports.
Table 4 Set Duplex Attribute for Ethernet Port
Operation Command
Set duplex attribute for Ethernet port. duplex { auto | full | half }
Restore the default duplex attribute of
Ethernet port. undo duplex
Table 5 Set Speed on Ethernet Port
Operation Command
Set 100M Ethernet port speed speed { 10 | 100 | auto }
Set Gigabit Ethernet port speed speed { 10 | 100 | 1000 | auto }
Restore the default speed on Ethernet port undo speed
Table 6 Set the Type of the Cable Connected to the Ethernet Port
Operation Command
Set the type of the cable connected to the
Ethernet port. mdi { auto }
Restore the default type of the cable
connected to the Ethernet port. undo mdi