Before Installing the Flash Memory Drive
1-3
For the NETBuilder II 8-Slot Extended system:
■
Flash memory drive, mounted on a tray
■
NETBuilder II Flash Memory Drive Diagnostic
diskette
■
This guide
4
In the space provided, copy the serial number from the label on the component
side of the flash memory drive.
Serial number:
Software Requirements
The flash memory drive needs version 6.2 or later of the NETBuilder software.
The Extended chassis needs version 8.0 or later of the NETBuilder software. Be
sure to use the CEC firmware that shipped with your software version.
Identifying Your System
This manual includes installation instructions for four kinds of systems:
■
4-Slot chassis (single-wide and dual-wide)
■
Dual-wide 8-Slot chassis
■
Single-wide 8-Slot chassis
■
Extended chassis
The assembly part number for each chassis is located on a label above the CEC
slot.
Table 1-2
lists the assembly part numbers for each chassis.
S/N 1BSXXXX
Serial number label
Table 1-2
NETBuilder II Chassis Assembly Part Numbers
Chassis
Assemby Part Number
Go to Page
Single-wide 4-Slot
20-0151-xxx
“Installing in the 4-Slot Chassis”
Dual-wide 4-Slot
20-0250-xxx, 20-0406-xxx, or 20-0457-xxx
“Installing in the 4-Slot Chassis”
Dual-wide 8-Slot
20-0249-xxx, 20-0407-xxx, or 20-0458-xxx
“Installing in the Dual-Wide 8-Slot Chassis”
Single-wide 8-Slot
20-0125-xxx
“Installing in the Single-Wide 8-Slot Chassis”
8-Slot Extended
20-0270-xxx or 20-0459-xxx
“Installing in the Extended Chassis”
