3Com CoreBuilder 7000, Инструкция по установке и запуску

Страница: 62 / 150

62 C
HAPTER
6: C
ONFIGURING THE
C
ORE
B
UILDER
7000 F
AMILY
ATM S
WITCH
PNNI Parameter Section If PNNI was selected as the routing mode, in
this section you are prompted to enter the PNNI node level, i.e., the
hierarchy level of the peer group to which it the node belongs. Enter a
value in the range 0 to 104.
LE Parameters Section In this section you are prompted to enable or
disable the resident LECS and LES of the switch. Enter values as follows:
1 At the “Resident LECS state” prompt, enter
1
to enable the resident LECS
or enter
0
to disable the resident LECS.
If you enter 1, the resident LES will be enabled automatically and no
further prompt will be displayed. If you enter 0, the “LES state” prompt
will be displayed.
2 At the “LES state” prompt, enter
1
to enable the resident LES or enter
0
to disable the resident LES.
The following example shows a typical LAN Emulation configuration.
LECS Address Section This section prompts you for the ATM address
of the LECS. Enter the complete LECS address; the network prefix is
identical to the network prefix of the switch. The following example
shows a typical LECS Address configuration:
Network Prefix
= -------------
Network Prefix(In HEX): 47.00.00.00.00.00.3c.00.00.a*
PNNI Parameters
=--------------
Enter PNNI Node Level [0 to 104]: 72
LE parameters
=------------
Resident LECS state (1-Enable, 0-Disable): 0
LES state (1-Enable, 0-Disable): 1