3Com CoreBuilder 7000, Инструкция по установке и запуску

Страница: 46 / 150

46 C
HAPTER
4: I
NSTALLING AND
C
ONNECTING
C
ORE
B
UILDER
M
ODULES
Connecting the
Control Terminal
The CoreBuilder 7000 family ATM switch can be configured via the LMA
using the Administration Console terminal (VT100) or terminal emulator
(Windows).
To connect a terminal to the CoreBuilder 7000 family ATM switch control
port:
1
Prepare an RS-232 shielded cable (9 pin-to-9 pin or 9 pin-to-25 pin, as
dictated by the terminal you wish to use).
2
Configure the terminal: 19200 baud, 8 data bits, 1 stop bit, no parity,
xon/xoff flow control.
3 Push the DCE side of the cable onto the Control port of the switch
module and screw it into place.
4 Connect the other end of the cable to the terminal.
In case you have installed a redundant switch unit, it is sufficient to
connect the RS-232 line to either the active switch control port or to the
redundant switch control port.
Connecting to the
Ethernet Port
The Ethernet port is used for connecting directly to a Transcend Network
Management System terminal for management purposes.
CoreBuilder
7201 (ATM port) SM-1300 -15 -33 18 15 SDX-1155B
CoreBuilder
7200F - Ethernet MM-820 -7.6 -15.1 7.5 HP#:HFBR-2416TC
HP#:HFBR-1414T
CoreBuilder
7200F - Ethernet SM N/A
CoreBuilder
7600FX MM-1300 -19 -31 12 HP#:HFBR-5103
CoreBuilder
7600FX SM N/A
OC-12 MM-1300 -19 -26 7 0.8 HP#:HFBR-5208
OC-12 SM -15 -28 13 15 HP#:SDX-1622
Table 8
Power Budget for Various 3Com Products (continued)
Product
Mode
(nm)
Min TX.
O-Pwr
(dBM) Receiver
Sens.
(dBM)
Budget
(dB) Distance
(KM)
Specification