3Com Switch 4500G Family
37
Command Reference
probe-failtimes
Use the
probe-failtimes
command to set the number of consecutive probe failures in an NQA test before
a trap message is sent to the network management server to indicate a probe failure.
NQA Test Group view
protocol inbound
Use the
protocol inbound
command to configure the protocols supported in the current user interface.
VTY User Interface view only
protocol inbound
Use the
protocol inbound
command to enable the current user interface to support Telnet, PAD, SSH, or
all of them.
VTY User Interface view
proxy-arp enable
Use the
proxy-arp enable
command to enable proxy ARP.
VLAN Interface view
public-key-code begin
Use the
public-key-code begin
command to enter RSA key code view.
Public Key view
public-key-code end
Use the
public-key-code end
command to return from public key code view to public key view and to save
the configured public key.
RSA Key Code view
put
Use the
put
command to upload a local file to the remote SFTP server.
FTP Client view
put
Use the
put
command to upload a local file to the remote SFTP server.
SFTP Client view
pwd
Use the
pwd
command to display the current path.
User view
pwd
Use the
pwd
command to display the current directory on the FTP server.
FTP Client view
pwd
Use the
pwd
command to display working directories on a remote SFTP server.
SFTP Client view
qos apply policy
Use the
qos apply policy
command to apply the associated policy on the port.
Gigabit Ethernet Port view
qos lr
Use the
qos lr
command to limit the rate of inbound or outbound traffic via physical interfaces.
Interface view
qos map-table
Use the
qos map-table
command to enter the specified priority mapping view.
System view
qos policy
Use the
qos policy
command to define a policy and enter policy view.
System view
qos priority
Use the
qos priority
command to configure the port priority of the current port.
Gigabit Ethernet Port view
qos sp
Use the
qos sp
command to configure SP queuing on the current port.
Ethernet Port view
qos vlan-policy
Use the
qos vlan-policy
command to apply a QoS policy to specified VLANs.
System view
