3Com 4210G Series, Руководство по настройке, Страница: 62 / 1133

2-11
To do... Use the command... Remarks
Display the global or
aggregation group-specific
load sharing mode
display link-aggregation
load-sharing mode
[
interface
[
bridge-aggregation
interface-number
] ]
Available in any view
Display link aggregation details
of ports
display link-aggregation
member-port
[
interface-type
interface-number
[
to interface-type
interface-number
] ]
Available in any view
Display the summary
information of all aggregation
groups
display link-aggregation
summary
Available in any view
Display detailed information of
aggregation groups
display link-aggregation verbose
[
bridge-aggregation
[
interface-number
] ]
Available in any view
Clear the LACP statistics of
ports
reset lacp statistics
[
interface
interface-type interface-number
[
to
interface-type interface-number
] ]
Available in user view
Clear the statistics of the
specified aggregate interfaces
reset counters interface
[
bridge-aggregation
[
interface-number
] ]
Available in user view
Link Aggregation Configuration Examples
Layer 2 Static Aggregation Configuration Example
Network requirements
As shown in Figure 2-1 , Device A and Device B are connected through their respective Ethernet ports
GigabitEthernet1/0/1 to GigabitEthernet1/0/3.
Aggregate the ports on each device to form a static link aggregation group, thus balancing outgoing
traffic across the member ports. In addition, perform load sharing based on source and destination
MAC addresses.
Figure 2-1
Network diagram for Layer 2 static aggregation
Configuration procedure
1) Configure Device A
# Configure the device to perform load sharing based on source and destination MAC addresses for
link aggregation groups.