3Com 4210G Series, Руководство по настройке, Страница: 57 / 1133

2-6
Load Sharing Mode of an Aggregation Group
The link aggregation groups created on the Switch 4210G Family always operate in load sharing mode,
even when they contain only one member port.
Link Aggregation Configuration Task List
Complete the following tasks to configure link aggregation:
Task Remarks
Configuring a Static Aggregation Group
Configuring an
Aggregation Group
Configuring a Dynamic Aggregation Group
Required
Perform either of the tasks
Configuring the Description of an Aggregate
Interface
Optional
Enabling LinkUp/LinkDown Trap Generation
for an Aggregate Interface
Optional
Configuring an
Aggregate Interface
Shutting Down an Aggregate Interface Optional
Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Optional
Configuring an Aggregation Group
z
The following ports cannot be assigned to an aggregation group: Stack ports, RRPP-enabled
ports, MAC address authentication-enabled ports, port security-enabled ports, IP source
guard-enabled ports, and 802.1x-enabled ports.
z
You are recommended not to assign reflector ports of port mirroring to an aggregation group. For
details about reflector ports, refer to
Port Mirroring Configuration
in the
Access Volume
.
Configuring a Static Aggregation Group
Follow these steps to configure a Layer 2 static aggregation group:
To do... Use the command... Remarks
Enter system view
system-view
—
Create a Layer 2
aggregate interface and
enter the Layer 2
aggregate interface
view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, a Layer 2
static aggregation group
numbered the same is created
automatically.
Exit to system view
quit
—