3Com 3CRWE920G73, Руководство пользователя

Страница: 11 / 85

3Com Corporation Page 10
Hardware Installation
Installing the 3CRWE920G73 Indoor Wireless Bridge
On a flat surface
1. Find a surface that is clear of debris.
2. Set the bridge down on its four rubber feet.
On a wall
1. Use the mounting template as a guide to make two marks 7.40cm (2.91 inches)
apart on the wall.
Use the vertical line on the template to ensure that the placement of the marks
is plumb to the wall.
2. Drill holes at the marks.
Use a 5-mm (3/16-inch) drill bit if using the provided screw anchors; use a
3-mm (1/8-inich) drill bit if using the screws only.
3. Install the two flathead screws at the marks on the wall.
Leave the screw heads protruding 6-mm (1/4 inch) from the surface of the wall.
4. Hang the bridge on the screws, using the mounting holes on the back of the
bridge.