32
4 To clear the display, press the
OK
button.
Activating Do Not Disturb
When you enable Do Not Disturb, incoming calls immediately go to the call coverage
point set by you or your administrator. The default call coverage point is your voice
mailbox. The call coverage point is set through the VCX User Interface (see
Chapter 6
).
When your telephone is in Do Not Disturb mode:
An incoming call does not cause your telephone to ring. If you are logged in to
multiple telephones using the same telephone number and one of the telephones
enables Do Not Disturb, the feature applies to all telephones—an incoming call will
not ring on any of the telephones.
You can use the telephone to dial outgoing calls.
If you enable Do Not Disturb, the pending calls are sent to your call coverage point
and Do Not Disturb is enabled for all subsequent calls.
If you are a Hunt Group or ACD group member and you enable Do Not Disturb,
personal (non-Hunt Group) calls go to your call coverage point. However, Hunt
Group or ACD group calls always ring on a member’s telephone, regardless of the Do
Not Disturb setting.
If your telephone is part of a bridged extension, see Do Not Disturb and Bridged Line
Calls
for additional information.
To activate Do Not Disturb:
1 Press the
Do Not Disturb
Access button on the telephone. The white light is lit next to
the
Do Not Disturb
button.
Your telephone is now in Do Not Disturb mode. The Display Panel shows Do Not
Disturb.
2 To disable Do Not Disturb mode, repeat step
1
.
The
DND
message disappears from the
Display Panel and the white light goes out.
Activating Malicious Call Trace
The Malicious Call Trace feature enables you to notify the system if you receive a
harassing or abusive call. The calling party can be from either an external or internal
source.
Malicious Call Trace cannot be invoked when you are on a conference call.
To activate malicious call tracing during a call, press
Feature
+
6
+
119
.
The Display Panel shows malicious call for 5 seconds.
The results of tracing a malicious call include the following actions:
Notification is sent to your network manager.
The log for the call includes a malicious call identifier.
For external malicious calls, the VCX system sends a message to the authorities
configured by your administrator to receive these reports.
