Invictus Installation Manual V2.1.25.3
Page 7
© 360 Vision Technology Ltd.
The INV-XALARM-PSU has eight normally open/normally closed (Dilswitch S1, switch 8 on) alarm inputs on
connector CON1 on the alarm PCB. When using normally closed contacts, all un-used alarm inputs must
be connected to alarm in common CON1. Connect switches or volts free relay outputs from PIRs or other
equipment to CON1 connector so that the terminal labelled COM is connected to the appropriate alarm input
(A1 to A8) when the alarm contact is activated. There is also an alarm relay which can be used to activate
alarms on other equipment (DVRs etc..). The alarm relay contacts (Common – ‘C’, Normally Open – ‘NO’ and
Normally Closed – ‘NC’) use connector CON3 on the alarm PCB.
When an alarm is activated, the ALARM PCB will activate the alarm relay output and will send commands to
set the Invictus to activate ‘alarm mode’. The Invictus will save the current status (pan, tilt, lens, tour and mimic)
then it will seek the preset which corresponds with the active alarm number.
The alarm will remain active while the alarm input is active. After the alarm input becomes inactive, a 10 second
alarm timer will start. The timer extends the alarm activity until the alarm timer expires. If the alarm input
becomes active again before the timer has expired, the timer resets and will restart again when the alarm input
becomes inactive and a further preset seek command is sent to the Invictus.
If an alarm is active and a further alarm becomes active, the latest alarm will interrupt the previous alarm. (i.e.
the latest alarm has highest priority) The Invictus will seek the preset that corresponds with the new alarm.
When the contacts become inactive, the Invictus will seek the preset that corresponds with the previous highest
priority alarm that is still active. When all alarms inputs are inactive the alarm timer starts. After the timer
expires, the Alarm PCB sends a command to the Invictus to end the ‘alarm mode’ and the Invictus will return
to the status position and action that had been saved when first alarm became active. (Fit a link on the alarm
card CON4 position 7 to disable the automatic return to the pre-alarm status when all alarms and the alarm time
have expired).
When an alarm is active and the Invictus has automatically selected the appropriate preset, it is possible to
send further commands (i.e. manual control) to the Invictus which will override the preset which had previously
been automatically selected. Each time an automatic preset seek occurs as described in the previous
paragraph; the manual control will be interrupted.
4.1 Standalone Alarmcard Setup
Alarm Number
Preset Number
1
1
2
2
3
3
4
4
Alarm Number
Preset Number
5
5
6
6
7
7
8
8
Address (1-7) (Range 1 to 128)
Use Dilswitch to set address same as camera.
(page 8).
Alarm Input setting
Use Dilswitch pole 8 to set if alarms are N/O or N/C. All
unused N/C contacts to be connected to alarm common.
(see page 8).
RS485 In Connections/LK3 termination
Connect RS485 from controller to CON6.
Power Connections
Connect 30vdc to CON7.
RS485 Out Connections/LK1 termination
Connect RS485 to camera to CON5.
Relay Output
Use CON3 for relay output.
Alarm Inputs
Use CON1 for volt free alarm inputs.
Protocol/Alarm settings
Use CON4 to set protocol and camera
alarm behaviour.
(see page 9).
