Page 74
TSS MINI Operations Manual
duration in the Duration window. The minimum duration is 4 seconds. The entry may be in
one of these formats:
Hours, Minutes, Seconds and Frames entered as HHMMSSFF
04300102 = 4 Hours, 30 minutes, 1 second, 2 frames
Hours, Minutes, Seconds and Frames entered as HH:MM:SS:FF
03:39:41:17 = 3 Hours, 39 minutes, 41 seconds, 17 frames
As a whole number along with the special characters H for hours, S for seconds, M for minutes.
7H would set 7 hour duration. 31m would set 31 minutes. 15s would set 15 seconds.
NOTE
: The Clip duration is affected only within the Playlist, for this event. The duration of the
source clip is not changed. Other events containing the same clip are not changed.
Mapping GPO to Playlist Events
The optional CXP-5 Auxiliary Interface Module has twelve General Purpose Interface
Outputs, referred to as GPO 1 through 12. Any of these can be programmed to go active at
a pre-determined time, or o
ffset,
after the beginning of a Playlist clip. An active d
uration
can
also be set, after which the output again goes inactive.
In all cases, every output will go
inactive when a clip ends.
By default, a new clip contains no programmed GPO output
commands. Refer to Appendix A – Connector Specifications for details on electrically
interfacing to the GPIO connector.
To Map a Playlist event to a GPO output, Follow these steps.
A.
Select
EDIT>CONFIGURE >GPO
.
The screen of
Error! Reference source not
found.
is displayed. GPO 1 through 12 correspond to the 12 GPIO outputs. The
checkboxes to the right of each selection represent channel 1, 2, 3 (and 4 in four
channel models). GPO 9 is shown with the trigger option pulldown expanded.
a.
Set the GPO of interest to
PLAYLIST
mode from the pulldown menu.
b.
Set the Channel to (video channel) 1, 2, 3 and/or 4 by checking the appropriate
box to the right. Click
APPLY
to activate the settings.
