TSS MINI Operations Manual
Page 23
unsuitable monitor is connected. Connect the monitor to the VGA port on the rear of the
unit using a VGA cable from the monitor or KVM. Refer to
Figure 1
.
Connect the keyboard and mouse to the available USB ports. Refer to
Figure 1
.
NOTE:
If using a CXP-5 control module, do not connect the CXP-5 control module to any
USB hub.
If you own more than one TSS MINI Server, it may be appropriate to use a single keyboard,
monitor, and mouse with a KVM switch to select between servers. Not all KVM switching
systems are compatible. The KVM switch must supply an active signal to the server at all
times, even when switched away from it. When first powering up the system, it is advisable
use only the supplied keyboard and mouse directly connected. Then test the KVM switch
system that will be used thoroughly before installation is completed.
Occasionally some KVMs will cause the mouse to stop responding or to behave erratically.
Mouse operation can be reset by the keyboard sequence Alt+F12 (the screen will
go black) followed by Alt+F7.