20
21
2VV.
Creating innovative solutions for you and your business since 1995.
MENU - OUTLET TEMP LIMITS
MENU - MODBUS RTU
MENU - NETWORK
Maximum temperature limit: 25°C - 45°C
IC-C Address:
1~247
Parity:
None
Odd
Even
Enabling/disabling DHCP
Manual entry of regulator
network settings:
IP address
Mask
Gate
Communication speed IC-C:
4800 Bd
9600 Bd
14400 Bd
19200 Bd
38400 Bd
Minimum temperature limit: 15°C - 20°C
This MENU enables limits to be set for exhaust from the
device
This MENU allows for the setting of communications pa-
rameters for the Modbus RTU
This MENU allows for the setting of communications pa-
rameters for network interfaces
Incorrect settings can lead to inability to communicate
with the regulator
Incorrect settings can lead to inability to communicate
with the regulator
If the MENU TEMPERATURE SENSOR contains the set
value “OUTLET”, the values cannot be set in this MENU,
because the limits are already defined by the sensor. This
screen is displayed:
MENU - FILTER TIMER
MENU - EXCHANGERS
MENU - TEMPERATURE SEN-
SOR
Current timer
status
Setting the desired time until
an alert appears on the main
screen of the display
1000h ~ 5000h
Sample display of status
of fouled filter on main screen
RESET button
(use after replacing
filters with new ones)
This MENU allows you to set the time (by motor hours)
after which an alert to replace filters is displayed, if applica
-
ble, to reset the timer after replacing filters
The type of heat exchanger the controlled device contains
may be set in this MENU.
Available in Automatic Mode only.
In this menu the temperature sensor that will be used for
primary temperature control can be selected
None
- no heat exchanger
Electric
- Electric heat exchanger
Water
- Water heat exchanger
Digital (5&6)
- digital output, connectors 5+6
Analog (19)
- analog output, connector 19
Only available for “Digital” selection:
1 step (5)
- 1 step heating, connector 5
2 step (5&6)
- 2 step heating, connectors 5+6
Available selections:
Outlet
-
Temperature sensor for exhaust from device (behind heat exchanger)
Inlet
-
Temperature sensor for part of device tray (before heat exchanger)
Room
- Spatial temperature sensor (for example, in the room)
Thermostat
- Spatial thermostat (functions ON/OFF)
Room BMS
- Spatial temperature sensor from master system
7. CONTROL
