2N BlueStar, Руководство пользователя, Страница: 84 / 177

Configuration Tool 3.4
84
Note

Tracing can be activated only for one session at a time. The other sessions
receive a BUSY message if requesting for tracing.
Settings Menu
This menu displays basic configuration settings of the configuration tool. In this
section you can choose a language and communication parameters.
Communication Settings
The configuration tool can establish the gateway connection either locally via a serial
line (RS232), or remotely via the TPC/IP – Telnet protocol, or via a modem. To set the
type of connection, use the
Setting > Communication settings section.
Communication types

Serial communication
Program communication through the RS232 serial interface at a transmission
rate of 57,600bps;

LAN communication
The configuration tool will try to establish the gateway connection via the
TCP/IP-Telnet protocol. In the case of normal connection, you will be
requested for the IP address, IP port, username and password of the remote
gateway. To connect with a gateway from the
Gateway list , the
configuration tool will use saved connection parameters.

Modem
An internal analogue modem is used.

ISDN modem
Communication through an ISDN modem and PRI card of the PRI gateway.
After selecting the required connection type, click on OK to select the proffered type
of connection.
ISDN Modem
Here configure the connected ISDN modem. The modem must support the X.75
transmission protocol.
Note

An HDLC chip is also located on the AUX board, enabling remote control
over the ISDN PRI interfaces. This chipset is an optional part of system.