2N ATEUS 501106E, Руководство пользователя

Страница: 47 / 67

45
Parameter
Par.
No.
Min. Max. Def.
Your
choice
Remarks
Number for automatic dialling 156 - 18 dig. - Empty = automatic dialling OFF
Time-out for automatic dialling 157 0 15 7 [sec], 0 = instantly after pick up
Maximal time of outgoing call
to GSM
158 0 2550 0
time [s], step = 10 s.
0 = without limit
Maximal time of incoming call
from GSM
159 0 2550 0
time [s], step = 10 s.
0 = without limit
SMS centre number 160 - 20 dig. - Necessary for SMS reports
COM – Data mode 161
0 1 1
0 = disabled, 1 = enabled
COM – SMS mode 162
0 1 1
0 = disabled, 1 = enabled
Enable sending call
information via COM
166
0 1 0
0 = disabled, 1 = enabled
Automatic data calls answering 181
0 15 0
Number of rings before
automatic answer.
0-do not answer automatically
Notes to Basic Parameters:
•
Parameters connected with SIM-card protection
The “PIN“ parameter is used only if “Enter Automatically” is selected and the SIM card
requires the PIN. If you enable the SIM-card function without PIN entering, you will not need
this parameter. If “Enter Automatically” is selected and you do not enter the PIN, enter a
wrong PIN, or replace the SIM card without entering the new PIN, the GSM Gateway will try
to enter the old PIN once, identify its invalidity, and invite you, if you try to dial, to enter the
PIN manually (by PIN tone
). If you enter the new PIN correctly, it will be
saved without programming. If you select the “Enter PIN Manually” mode, you will have to
enter the PIN upon every power-on and the GSM Gateway will not store it anywhere.
•
Parameters connected with GSM network
CLIR (number of the calling extension, i.e. of your GSM Gateway) is normally sent to the
called party. The “Incognito” option should be applied for with your GSM operator (usually
for a single fee).
WARNING!!! If you have not activated this service with your GSM operator
and set the “Incognito” function at 1 = Do Not Send Number, no outgoing calls will be
established in some GSM networks!!!
There is a risk with roaming in frontier areas that, due to a failure in your native GSM
network, the GSM Gateway might get registered in a GSM network of the neighbouring
country and all GSM calls will be much more expensive. If you enable roaming, you should
set your SIM card properly and activate the service with your operator! If you disable
roaming here, it is an unambiguous barring command that depends on nothing else.
Incoming call enable: The GSM Gateway is designed for outgoing calls primarily, because
you mostly do not pay for incoming calls and thus cannot cut your telephone costs. If, however,
incoming calls occupy the GSM Gateway for a considerable period of time, this might make
your outgoing calls more difficult and diminish the expected cost cuts. Should your GSM
Gateway be too busy, you are advised to bar incoming calls. To cut incoming call costs too
(from employees moving outside the company, e.g.), you can install another GSM Gateway for
incoming calls only using a SIM card with pre-paid services (no monthly lump sum will be paid).
•
Volume and echocanceller setting
Parameters 104 and 105 allow changing of volume by +/- 6 dB around its nominal value
in
3dB
steps.