2N 9137111CKU, Руководство по установке

Страница: 82 / 113

Installation manual 2N® IP Vario
82 / 113
•
•
•
Status signalling:
Green LED Red LED Status
blinking off Operational mode
on off Activated output
blinking blinking Programming mode – waiting for
initialisation
on blinking Error – wrong code received
Configuration:
Connect the 2N
®
Security Relay to the properly set intercom switch output; refer
to the Configuration manual for 2N IP intercoms . Make sure that one LED at least on
the 2N
®
Security Relay is on or blinking.
Press and hold the 2N
®
Security Relay Reset button for 5 seconds to put the device in the
programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent from
the intercom will be stored in the memory and considered valid. After code initialisation,
the
2N
®
IP Security Relay will pass into the operational mode (the green LED is blinking).
•
Caution
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
2N
®
Security Relay using the instructions above.
