2N 01368-001, Руководство по установке, Страница: 93 / 107

2N Access Unit Installation Manual
93 / 107
•
• To the switched output.
To the passive output in series with the external power supply.
The device also supports a Departure button connected between the ‘PB’ and ‘– HeliosIP/2N IP
intercom’ terminals. Press the Departure button to activate the output for 5 seconds.
Status signalling
Green LED Red LED Status
flashing off Operational mode
on off Activated output
flashing flashing Programming mode – waiting for
initialisation
on flashing Error – wrong code received
Configuration:
Connect the 2N
®
IP Security relay to the properly set access unit security output. For settings
refer to the 2N Access Unit Configuration Manual is installed. Make sure that one LED at least is
on or flashing.
Press and hold the 2N
®
IP Security relay Reset button for 5 seconds to put the device in the
programming mode (both the red and green LEDs are flashing).
Activate the output switch using the keypad, telephone, etc. The first code sent from the
intercom will be stored in the memory and considered valid. After code initialisation, the
2N
®
IP Security relay will pass into the operational mode (green LED flashing).