2N 01368-001, Руководство по установке, Страница: 87 / 107

2N Access Unit Installation Manual
87 / 107
•
•
•
•
•
•
•
•
•
•
•
•
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes a 220 mm long interconnecting cable.
Important module properties:
FBI PIV and Mobile ID certification – FAP20
Durable glass touch surface
Rejects spoof fingerprints
− 20 to 55 ºC operating temperature range
0–90% relative humidity, noncondensing
I/O Module
The I/O module ( Part No. 9155034 ) is used for extending of the number of inputs and outputs.
The module contains two bus connectors for 2N Access Unit .
These two connectors are fully interchangeable and can be used either as inputs from the
basic unit or outputs to other modules.
If this module is the last one on the bus, one of the connectors remains unconnected.
The module package includes an 80 mm long interconnecting cable.
The inputs / outputs are addressed as follows: <module_name>.<input/output_name> ,
e.g. module5.relay1. Configure the module name in the Module name parameter in the
Hardware / Extenders menu.
•
•
Note
A higher moisture may deteriorate finger papillary line scanning. You are advised
to dry your finger and the reader scanning surface for successful authentication.
Fingerprint scanning can be rather difficult with older persons whose papillary
lines are no so distinct (lower finger elasticity due to age requires a higher pressure
for scanning and the fingerprint might be blurred).
