CS400 DIRECTSTART
REMOTE CAR S ALARM
CS400 VERSION 412
6
BANK
BANK
BANK
BANK 1
1
1
1 PROGRAMMING
PROGRAMMING
PROGRAMMING
PROGRAMMING
FUNCTIONS
FUNCTIONS
FUNCTIONS
FUNCTIONS
OPTIONS
OPTIONS
OPTIONS
OPTIONS
1 - Door lock
*
Option 1 :: Active door lock
Button 2 : Passive door lock (Doors/Alarm lock w/ Interrupt Circuit)
Button 3 : Erase all learned code and reset to original default
Note Option #3 will (A) erase all transmitters. (B) Reset factory defaults (C) Exit programming & enter armed state
.
2 - Interrupt Circuit
*
Option 1 :
Active Arming
J2-PIN#6 (BROWN)
Option 2 :
Passive arming (arm after 30 sec. Ign. off
Option 3:
Passive arming (arm after 60 sec. Ign. off)
3 - Lock/Unlock Timing
*
Option 1 : Lock 1 sec. / Unlock 1 sec.
Option 2 :
Lock 1 sec. / Unlock 2 pulses of 0.5 sec.
Option 3 : Lock 4 sec. / Unlock 4 sec
4 - Prog. Output #1
*
Option 1 : Button 3 (#) - 1 sec. output only if ign. off (trunk)
J2 –PIN#4 (GREY)
Option 2 :
Button 3 (#) - 1 sec. output (garage door)
5 - Ignition Lock
*
Option 1 : Ignition Lock Off
Option 2 : Ignition Lock and Unlock
Option 3 :
Ignition Lock only
6
-
Cold start
*
Option 1 :
Cold start mode enable with 2 hours intervals
Option 2 : Cold start mode enable with 4 hours intervals
Option 3 : Cold start disable
7- Run time
*
Option 1 : 15 minutes
Option 2 :
20 minutes
Option 3 :
10 minutes
8 - *Alarm Setting
*
Option 1 : Alarm & Ignition Tamper OFF
Option 2 :
Alarm & Ignition Tamper ON
9
-
Ext. trigger
*
Option 1 :
External Start trigger enable. No Alarm zone3
.
J2-PIN#3(Wht/ Purple)
Option 2 : Ext. trigger input used as alarm trigger zone 3
.
*Note- This input acts as an alarm input trigger only on automatic transmission vehicles. In Manual
transmission mode this input is used as the safety hand brake connection and overrides all other
options.
*Alarm Settings must be enabled inorder to activate intrusion alarm features. Function 8 above.
**To enable Passive Arming Intrusion Alarm features you must change doorlock option to passive
locking (Bank I, Function 1, OPTION 2).
