CS400 DIRECTSTART
REMOTE CAR S ALARM
CS400 VERSION 412
4
TRANSMITTER
TRANSMITTER
TRANSMITTER
TRANSMITTER
(Description & Operation)
(Description & Operation)
(Description & Operation)
(Description & Operation)
BUTTON #1
"LOCK"
Icon
Button #I
(
Lock Icon
) is used to
LOCK
(
Optional
) electric door locks and/or
ARM
engine interrupt
circuit and/or intrusion alarm. A
LOCK/ARM
signal is sent each time the
Button #I
is pressed.
Parking lights flash
once
to confirm. (Horn chirp is
Optional
).
BUTTON #2
"START"
Icon
Button #II
is used to
Remote Start
your vehicle.
BUTTON #3
"UNLOCK "
Icon
Button # III
is used to
UNLOCK
(
Optional
) electric door locks and/or
DISARM
engine interrupt
circuit and or intrusion alarm options. Parking Lights flash
twice
to confirm . (Horn chirp is
Optional
)
NOTES
:
* You cannot arm the system if the IGNITION KEY is in the ON position.
** Engine Interrupt Circuit can be programmed for
PASSIVE or ACTIVE Arming. Bank I, Function 2
***Door Locks can be programmed for
PASSIVE or ACTIVE ARMING
.
Bank I , Function 1.
*Note
Alarm Settings must be enabled
(Bank I, Function 8)
in order to activate the Intrusion Alarm
features to be programmed for
ACTIVE or PASSIVE ARMING (Bank I, Function 1)
TRANSMITTER
TRANSMITTER
TRANSMITTER
TRANSMITTER PROGRAMMING
PROGRAMMING
PROGRAMMING
PROGRAMMING
1. Open the hood. (J2-PIN#14 Violet hood switch wire must see ground )
2. Toggle the Ignition Key ON and OFF 8 times…(Start and Finish in the OFF position)
Parklights will come on solid to indicate system is in Transmittter learning mode.
3. Press ‘LOCK‘ Button to program (learn) the transmitter. System will confirm transmitter is
programmed correctly by flashing the parking lights (1) one time if Tx is new to the system
or (2) twice if Tx has previously been learned (programmed).
4. Transmitter is now programmed to operate the system. At this point you have the option of
A) Exiting programming mode by turning the IGNITION KEY to the ON position.
B) Proceeding directly into Function programming by pressing (LOCK) Button I to
select Bank I Function Settings or (START) Button II to select Bank II Function
Settings.
*NOTE: ONLY ONE TRANSMITTER CAN BE PROGRAMMED AT A TIME, THE TRANSMITTER
PROGRAMMING SEQUENCE MUST BE REPEATED FOR EACH NEW TRANSMITTER
.
**NOTE: A MAXIMUM OF 6 TRANSMITTERS CAN BE LEARNED PER SYSTEM
.
System Programming Automatically follows after each transmitter is programmed unless the ignition is turned
to the ON position to exit programming mode altogether.
