14.5
171
33.5
222.5
14
20.25
195.70
12.70
13
4mm
33.5
222.5
14
20.25
measurement from bottom of
jamb to strike plate
60 °
20.25
222.5
33.5
R5
A
Please note: Dimensions for lock and handles have all clear-
ance
added and all dimensions are set to fit lock easily.
P 09 828 9664 E [email protected] W zebratti.co.nz
31-33 Timothy Place, Avondale, Auckland
0917
Sliding Door Lock
Installation Instructions
Aluminium 40mm Backset
2.
Cut holes out for handles on either face of the door, this
will be 14mm (critical) above the bottom of lock cut out,
and 20.25mm from the door edge (A).
3.
File Bottom inside edge of handle cut out to remove
extrusion fins.
4.
Drill 4mm holes for 10g screws to attach face plate onto
door edge.
6.
Tighten grub screw to lock handles into place.
7.
Insert Second handle Into frame, following steps 6 and 7
with the driving pin connecting into the Handle.
8.
Push the euro cylinder lock through lock assembly,
Tighten screw to lock cylinder in place.
9.
Align and Centre strike plate opposite the lock latch to
suit engagement, measure the position of the strike plate
from bottom of jamb. Mark and Drill holes for 10g screws
to attach strike plate.
10.
Check lock engagment and use adjustment with
screws if necessary.
11.
Place Strike plate cover onto base and adjust with
screws for close fit.
1.
Cut out hole for lock in the centre of the stile. (only if
stile is symmetrical.)
5.
Insert rear handle as shown, insert pin (& button on sin-
gle handles) through lock driving block and through to the
handle which opens and closes the lock.
Critical
LCS
