E
GB
TO SET CLOCK
When the battery is first connected the display is set to clock
mode.To set the correct time:
1. Press '
HOUR
' button, and hours will flash.
2. Use '
MIN
' button to scroll to correct hour.
3. Press '
HOUR
' button again and minutes will flash.
4. Use '
MIN
' button to scroll to correct minutes.
5. Press '
HOUR
' button again to confirm settings.
The battery compartment is located on the back of the timer.
Insert battery (1 x AAA) observing the + and - polarity signs in
side the battery compartment. Replace cover.
TO SWITCH BETWEEN CLOCK & TIMER MODE
To switch from clock to timer mode, press the '
START/STOP
'
button once.The display will automatically switch back to clock
mode 1 minute after the timer has finished or, if the timer has
been set but not started, within 1 minute.
TO USE COUNTDOWN
1. First switch to timer mode.
2. Set required time period by pressing '
HOUR
' or '
MIN
'
buttons. Numbers will advance quickly if the button is held
down. (maximum 19 hours 59 minutes).
3. To start timing press '
START/STOP
' button once.
On the display the '
:
' will start to flash. Pressing the
'
START/STOP
' button can temporarily stop the timer.
Pressing the '
START/STOP
' button again will restart it.
4. When the time is up, the alarm will sound for
approximately 60 seconds.
5. To stop the alarm sounding press the '
START/STOP
'
button once.The display will revert to the previous time
setting (
memory
).
6. To clear the display to '
0:00
' press '
HOUR
' and '
MIN
'
buttons simultaneously.
MINUTE MINDER
For countdown periods of over 10 minutes, the timer will
"Bleep" twice to warn you that there are 10 minutes of timing
left.When the countdown reaches 5 minutes the timer will
"Bleep" 4 times to inform you there are only 5 minutes left.
TO USE COUNT-UP
1. The timer can be used to count-up in minutes and seconds
to a maximum of 19 minutes and 59 seconds.
2. Press '
HOUR
' and '
MIN
' buttons at the same time to
reset the display to '
0:00
'.
3. Press the '
START/STOP
' button once to start count-up.
4. To stop the count-up at any time, press the '
START/STOP
'
button once.To resume count-up press the '
START/STOP
'
button again.
USE AND CARE
•
Wipe clean with a dry cloth.
DO NOT
immerse in water.
DO NOT
place on or near hot ovens etc.
•
Use 1 x AAA battery type. If the display begins to disappear
or alarm sound faint, check battery contact and then try a
new battery. Always remove flat batteries.
GUARANTEE
Salter will repair or replace this product *, free of charge if
within a year of the date of purchase it can be shown to have
failed through defective workmanship or materials.This
undertaking is in addition to a consumer's statutory rights
and does not affect those rights in any way.
*
Excludes batteries.
REF: SL141
Stainless Steel Timer & Clock
TO INSTALL BATTERY
E
FG
211 Vale Road,Tonbridge,
Kent,TN9 1SU. England
