Install Guide CT110
Caution
•
Turn off electricity to the HVAC system
before installing or
servicing thermostat or any part of the system.
• Do not turn electricity back on until work is completed.
• Do not short (jumper) across electric terminals at the control
on the furnace or air conditioner to test the system. This may
damage the thermostat.
• All wiring must conform to local codes and ordinances.
• This thermostat is designed for use with 24 volt AC HVAC
and millivolt gas systems. The thermostat is powered by 4AA
alkaline batteries and/or 24 volt AC C wire (or a 12-24 AC or
DC source). Each thermostat relay load should be limited to 1.0
amp; higher amperage may cause damage to the thermostat.
• Your thermostat is a precise instrument, handle it with care.
Caution
To avoid electrical shock and
to prevent damage to the furnace, air conditioner, and
thermostat,
disconnect the power supply
before
beginning work. This can be done at the circuit breaker.
1308-001-001
INSTALLATION
ENGLISH
Temperature
adjust buttons
Z-Wave join
Button
Indicators
LCD screen
MODE
button
Reset
Button
FA
N
button
Wall Plate
and
Wall plate frame
Thermostat
