CC908RF
Easy Bind guide
Important:
If you have more than one transmitter you will need to change the DIP Switches near the
batteries on the inside of the thermostat. This will avoid interference between units.
To bind a thermostat to a receiver:
1) Press the learn button on the receiver so that the power light goes out.
2) Press and hold the learn button until the learn light lights
4) Insert the batteries into the transmitter and close the unit
5) The learn light on the receiver will flash a few times and go out
6) Press the learn button again so that the power light comes on
7) The transmitter and receiver are now bound.
The on light should come on when the transmitter is calling for heat (flashing flame), and go off
when the room is up to temperature (solid flame). Ensure the ON/OFF override button on the
receiver is in the off position for it to work on the thermostat. It can be pressed into the on position
to bring the heater on in the event of communication failure.
