Document 800-22732 – Rev A – 11/2016
Performance Series HQA HD30HD4
4 MP IR Ball Camera
1
Quick Installation Guide
Document 800-22732 – Rev A – 11/2016
Thank you for purchasing a Honeywell
Performance Series HQA HD30HD4 camera.
Follow the instructions in this guide to install and
set up your camera.
Cautions and Warnings
Important Safeguards
•
Read and keep these instructions.
•
Do not aim the camera toward a bright light source for extended periods to prevent damage to the imager.
Avoid operating the unit under or close to unstable light sources or close to fluorescent lamps or objects
reflecting light.
•
Do not touch the camera lens.
•
Do not drop the camera or subject it to physical shock.
•
Do not use a strong or abrasive detergent when cleaning the camera.
•
Avoid operating or storing the unit in extremely humid, dusty, or environments where the operating
temperature is outside the recommended range of –22°F to 140°F (–30°C to 60°C).
Before You Begin
Before you begin, check that you have received all of the parts listed below. If any parts are missing or damaged,
contact your dealer immediately.
Tools needed (not supplied):
Preparing the Mounting Surface
1.
Inspect the site where you want to install the camera. The mounting surface must be flat and capable of
supporting at least three times the weight of the camera.
2.
Remove the backing from the mounting template sticker and affix the sticker to the mounting surface.
3.
Drill the screw holes and cable exit hole at the locations indicated on the mounting template sticker.
4.
Insert the four supplied plastic anchors in the holes.
5.
Pull the power and video cables through the hole.
Mounting the Camera
1.
Remove the mounting base from the camera.
a.
Loosen the one set screw on the base ring.
b.
Unscrew the base ring from the mounting base.
2.
Attach the mounting base to the mounting surface
using the supplied screws.
3.
Connect the camera’s power and video cables.
WARNING
This device is configured for 12 V DC operation. Do not connect to a higher
voltage. Use only with NRTL-approved Class 2 power supplies.
WARNING
IR emitted from this product. Do not view directly with optical instruments.
Do not stare directly into the lamp at a distance of less than 3.3 ft (1 m).
CAUTION
Class 1 LED product. Invisible LED radiation (850 nm). Avoid exposure to beam.
4 - Ø0.18" (Ø4.5 mm)
Ø2.72" (Ø69.0 mm)
Ø4.17" (Ø106.0 mm)
3.69" (93.7 mm)
•
Camera
•
Self-tapping screws (4)
•
Allen key (L-wrench)
•
Quick Installation Guide
•
Plastic anchors (4)
•
Mounting template sticker
•
Power pigtail
•
Cordless drill
•
Phillips screwdriver
1
Ceiling or wall
Plastic anchors
Camera mounting
base
Self-tapping screws
Ball camera body
Lock screw
Camera base ring
2
