Model 54A00-1 HAI Access Control Keypad
Home Automation, Inc
.
DESCRIPTION
The Model 54A00-1 HAI Access Control Keypad is a weatherproof and vandal resistant piezoelectric keypad designed to interface
with the HAI line of automation controllers. Each valid code can be used to arm and disarm the security system, activate an electric
door strike or magnetic locks, activate lighting, operate a garage door, operate a security gate, set off a panic alarm, and many other
functions.
The keypad is encased in a stainless steel investment casting that will complement any décor. It mounts in a single gang switchbox or
to the surface of any wall indoors or outdoors. The keypad has a red LED that is illuminated when the security system is armed and a
green LED that is illuminated when it is disarmed.
INSTALLATION
The Model 54A00-1 requires the use of one serial port on the controller and one programmable voltage output. Multiple keypads may
be connected in parallel as shown in Figure 1.
Run a 4-conductor cable from the controller to the location of the Model 54A00-1 Access Control Keypad and install as follows:
1.
At the keypad location, using the supplied B-GEL water-tight wire splice connectors, connect the black, red, white, and
brown wires of the keypad cable (P/N: 54A03-1) to the corresponding wires of the 4-conductor cable as follows:
Keypad Cable (P/N: 54A03-1)
4-Conductor Cable
Black Black
Red Red
White Yellow
Brown Green
2.
Insert the keypad cable into the connector on the back of the keypad.
3.
Install the 54A00-1 to the surface of any wall using the supplied wall anchors and screws or to a single gang switchbox using
the supplied machine screws.
4.
Adhere the top (with LED cutouts) and bottom (with HAI logo to bottom right) overlay to the 54A00-1 by removing the
backing and pressing into place.
5.
At the controller location, connect the black, red, green, and yellow wires of the keypad communications cable
(P/N: 54A02-1) to the corresponding wires of the 4-conductor cable using the supplied wire splice connectors as shown.
6.
Connect the green wire of the keypad communications cable (P/N: 54A02-1) to one of the programmable voltage outputs on
the controller as shown. Configure the voltage output as an “Armed” output
7.
Connect the red wire of the keypad communications cable (P/N: 54A02-1) to the Auxiliary 12V output on the controller as
shown.
8.
Insert the modular connector of the keypad communications cable (P/N: 54A02-1) into one of the serial ports on the
controller as shown. Configure the serial port to Pro-Link.
(Connections Diagram on Next Page)
