Installation Manual
FES20 Series ELECTRIC STRIKE
PRODUCT
FES20 Non Monitored Strike (not SCEC approved)
FES20M Monitored Strike (SCEC approved)
FES20M-L2 Monitored Strike Lipless (SCEC approved)
FES20M-R Monitored Strike with additional integrated Reed Door Position Switch (DPS) (not SCEC approved)
ACCESSORIES
MORTICE LOCK FACEPLATES EQUIPPED WITH A SET OF MONITORING MAGNETS
FES20-EL 15
FES20-EL 25
FES20-EL 50
FES20-EL 75
Australian Lock Company FES20MR-AUS
DORMA FES20MR-DOR
KABA FES20MR-KAB
Legge FES20MR-LEG
Lockwood FES20MR-LOC
Nova FES20MR-NOV
Other mortice lock types or cylindrical locks on request
WIRING
When installation of the strike and the mortice lock face plate is completed, connect the wiring according to list below:
Grey
Grey
Normally Open Contacts
Door Position Switch
0.5A, 30VDC
Multi Voltage 11-30VDC 12 VDC – current 220 mA
Red (+) Black (-)
Black (Common)
Yellow (NO-PTO); (NC-PTL) Green (NC- PTO); (NO-PTL)
Black (Common)
Blue (NO) Orange (NC)
Black (Common)
Red (NO) White (NC)
LSS Sensor Output
3 A, 125 VAC;
2 A, 30 VDC.
DSS Sensor Output
3 A, 125 VAC;
2 A, 30 VDC.
Anti-tamper Sensor Output
5 A, 125 VAC;
3 A, 250 VAC.
24 VDC – current 110 mA
DPS (Door Position Status)
Power Input
Wire output
LSS (Lock Status Sensor)
DSS(Door Status Sensor)
ATS (Anti – tamper Sensor)
Sensor Output
122
122
122
10
5
24
26
28.5
175.6
39.5
122
26
10
28.5
3
23
5
138
122122
PRODUCT DIMENSIONS
The FES20M-R monitored Electric Strike is equipped with an integrated Reed Door Position Switch (DPS). This function requires a special
Mortice Lock Face Plate equipped with a set of magnets to operate in combination with the FES20M-R Electric Strike.
FSH is providing a range of face plates from 6 manufacturers (see above). Face plates from other manufacturers on request.
NOTE
FES20 Series Electric Strike factory setting is Power to Lock (PTL) .
The control circuit for the door strike is protected against reverse polarity connection. No additional diode protection required.
see new separate Manual for FES20M
