![background image](http://html.mh-extra.com/html/deco-lighting/skyler/skyler_installation-instructions_2461798001.webp)
Deco Lighting practices a program of continuous product improvement, and as a result product specifications change frequently. We reserve the right to change
product specifications without notice. Contact Deco for the latest product information.
2917 Vail Ave., Commerce, CA 90040 • (800)613-DECO (3326) • [email protected] www.getdeco.com
1
Skyler
Volumetric Flat Panel Luminaire
Installation Instructions
1. Read carefully before installing fixture. Retain for future reference.
To prevent electrical shock, turn off electricity at fuse box before proceeding.
This equipment is intended to be installed only by qualified personnel. The installation must be made in accordance with the current
edition to the National Electric Code and all applicable state and local building codes. The final installation must be approved by the
appropriate qualified electrical/building inspector(s). Improper installation may result in a fire or electrical hazard. Be sure the electrical
power to the circuit has been disconnected before installing this electrical system.
1. Review the diagrams thoroughly and disconnect all electrical power before installation to avoid electric shock.
2. Do not mount near flammable materials or electric heaters.
3. Do not let power supply cords touch hot surface.
4. Fixture is for indoor and damp location, Do not use for outdoor location.
5. The fixture shall be installed or maintained by qualified electrician or person who is familiar with the luminaires.
The Skyler recessed luminaire is designed to be installed in 2x2 and 2x4 recessed t-bar ceilings, and is suitable for 15/16”, 9/16”, and
9/16” screw slot ceiling types.
IMPORTANT SAFETY INSTRUCTIONS
- Ensure that power is fed to the luminaire location, following local and national electrical codes.
- Ensure that the ceiling grid has sufficient support. Iron structural wire must tire the grid to structure above, following local and national
building codes, and grid manufacturer specifications.
Installation Instructions
1. Prepare ceiling
- Remove tile where the luminaire will be located, and the tiles adjacent.