AndyMark AM14U4, Battery Mount Installation

Page: 1 / 2

AM14U4 Battery Mount Installation
Robotics is a high-contact sport. It’s important to keep your battery protected and
secured during the match. AndyMark recommends using this vertical mount to
securely hold the battery and conveniently mount your robot power connector.
Battery Tray Parts
Component Part Number QTY Part Photo
10-32 x 0.5 SHCS am-1002 8
10-32 x 1.5 SHCS am-1014 2
1/4-20 x 0.75” Thread
Rolling Screw am-1310 4
10-32 Nylock Jam Nut am-1063 10
6-32 x 0.750 HHS am-1424 2
6-32 Nylock Jam Nut am-1419 2
500 Churro, 3.375" am-2569 2
Battery Strap am-3965a 1
Lower Strut Spacer am-3876 2
Battery Bottom Plate am-3959 1
Battery C-Plate am-3958 1
Battery Clamp am-3960 1
Note : The assembly may need to be slightly flexed to fit
over the flanges on the End Plate.
Step 1: Place two 3.375” Churros (am-2569) between
the Bottom Plate (am-3959) and the C Plate (am-
3958). Secure the Churros to the plate with four ¼-20
x 0.750” Thread Forming Screws (am-1310). Make
sure the tabs on both plates are pointing upwards.
Step 2: Slide the assembly over the End Plate such that
the Strap Clamp (am-3690) and Battery Strap (am-3965)
are centered between the ends of the C Plate. The C Plate
and Bottom Plate should be installed on the top and
bottom of the flanges on the End Plate, respectively.