ZyXEL Communications ZyXEL Prestige 660R, User Manual

Page: 67 / 297

Prestige 660R ADSL 2+ Access Gateway
WAN Setup 6-7
Table 6-1 WAN Setup
LABEL DESCRIPTION
PPPoE +
PPPoE_Client_PC
(PPPoE
encapsulation only)
In addition to the Prestige's built-in PPPoE client, you can enable PPPoE pass through
to allow up to ten hosts on the LAN to use PPPoE client software on their computers to
connect to the ISP via the Prestige. Each host can have a separate account and a
public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not
appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP.
Subnet Mask
(ENET ENCAP
encapsulation only) Enter a subnet mask in dotted decimal notation.
Refer to the
Subnetting appendix on how to calculate a subnet mask If you are
implementing subnetting.
ENET ENCAP
Gateway
(ENET ENCAP
encapsulation only) You must specify a gateway IP address (supplied by your ISP) when you select ENET
ENCAP in the Encapsulation field
Back
Click Back to return to the previous screen.
Apply Click Apply to save the changes.
Cancel Click Cancel to begin configuring this screen afresh.
6.6 Traffic Redirect
Traffic redirect forwards traffic to a backup gateway when the Prestige cannot connect to the Internet. An
example is shown in the figure below.