ZyAIR G-220 User’s Guide
Maintenance
4-1
Chapter 4
Access Point Mode Configuration
This chapter shows you how to configure your ZyAIR in access point mode.
4.1 Introduction
To set your ZyAIR as an Access Point (AP), refer to
Section 1.5.1
.
In access point mode, your ZyAIR functions as an access point. This allows you to set up your wireless
networks without using a dedicated AP device. Up to 16 wireless stations can associate to the ZyAIR.
4.1.1 Additional Setup Requirements
To bridge your wired and wireless network using the ZyAIR, the following requirements must be met:
1. The ZyAIR must be installed on a computer connected to the wired network.
2. Either configure network sharing (refer to the appendix
for an example) or bridge the two interfaces
(wireless and wired) on the computer.
3. Set the wireless station’s IP address to be in the same subnet as the computer in which the ZyAIR is
installed. Refer to the
Setting Up Your Computer’s IP Address
appendix.
4.2 The ZyAIR Utility Screen
Select
Access Point
in the
Mode
field to display the screen as shown.
