ZyXEL Communications ZyAIR G-2000 Plus, User Manual

Page: 361 / 430

ZyAIR G-2000 Plus User’s Guide
Chapter 34 Firmware and Configuration File Maintenance 360
5 Use the TFTP client (see the example below) to transfer files between the ZyAIR and the
computer. The file name for the firmware is “ras
” and the configuration file is “rom-0”
(rom-zero, not capital o).
Note that the telnet connection must be active and the SMT in CI mode before and during the
TFTP transfer. For details on TFTP commands (see following example), please consult the
documentation of your TFTP client program. For UNIX, use “get” to transfer from the ZyAIR
to the computer, “put” the other way around, and “binary” to set binary transfer mode.
34.4.5 Example: TFTP Command
The following is an example TFTP command:
TFTP [-i] host put firmware.bin ras
where “i” specifies binary image transfer mode (use this mode when transferring binary files),
“host” is the ZyAIR’s IP address, “put” transfers the file source on the computer (firmware.bin
– name of the firmware on the computer) to the file destination on the remote host (ras - name
of the firmware on the ZyAIR).
Commands that you may see in third party TFTP clients are listed earlier in this chapter.