Chapter 3: The Web Configurator
ZoneDAS User Guide
Page | 28
The following table describes the sub-menus:
Table 7
Navigation Panel
MENU
SCREEN
FUNCTION
Home
Home
This is the main Web Configurator screen. From here, you can view and
monitor each ZoneDAS device and its connection status, including the BU
and its connected Extenders / RUs.
BU
Use this screen to view/modify the BU’s basic information, plus monitor each
BU-RF’s status, downlink system gain, and input power.
RU1~RU8
Use this screen to view/modify each RU’s basic information, plus monitor each
RU-RF’s status, temperature, and output power.
Setting
BU Settings
Use this screen to configure each BU-RF’s connection settings.
RU Settings
Use this screen to configure each RU-RF’s signal output settings.
Advanced
Settings
Use this screen to configure the system’s auto leveling settings.
Fault
Active Alarms
Use this screen to view and clear the system’s current alarms.
Past Alarms
Use this screen to view a history of all system alarms. Filters are available by
category, severity, etc.
Alarm Settings Use this screen to modify each alarm type’s severity level, SNMP activation
mode, and SNMP alarm delay.
System Log
Use this screen to view the ZoneDAS system log and to set up the system log
server’s IP.
System
Network
Use this screen to view and modify the system’s VLAN, VPN, and Main
Interface (MGMT port) settings.
SNMP
Use this screen to configure the system’s SNMP (Simple Network Management
Protocol) settings.
Time Setting
Use this screen to configure the system’s time and date settings.
Maintenance
Firmware
Use this screen to upload and install new firmware for the system’s various
components.
Config File
Use this screen to backup or restore system configurations.
User Account
Use this screen to create and manage up to 8 user accounts via configuring
user names, passwords, and privilege levels.
Restart
Select this to reboot the BU and all connected RUs (not including Extenders).
This option may be suitable if and when the system becomes unstable.
